Operation; Before Use; Installing The Handle; Connecting The Device - AEG LT60 Bedienungsanleitung

26 www.aeg-automotive.com

oPeraTIon

Before use

Caution!
risk of injury whilst unpacking due to e�g� pinching
or falling pieces� remove the charger from the
packing with two people and watch for moving and
loose parts�

Installing the handle

note: you will need a cross-tip screwdriver for
assembly�
1� remove the screws on the handle (9) for
transport�
2� flip the handle up and secure the handle with
two screws at each side�
Warning!
before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices�
•
Use safety goggles and acid-proof safety gloves�
•
ensure adequate ventilation�
•
ensure the battery poles are clean� If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed�

Connecting the device

1� connect the red (+) terminal connection cable
with clamp (3) to the positive battery terminal�
2� connect the black (-) terminal connection cable
with clamp (2) to the negative battery terminal�
note:
The black (-) clamp can also be connected to the
vehicle chassis (Please refer to the auto maker's in-
structions!)� be sure both clamps have good contact
and are securely seated�
Warning!
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable� In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable�
3� Plug the charger plug into a 230V power socke�
The leD will light up
•
5 a (green)
•
12 V (blue)
•
sTD (red)
The display shows the current battery voltage�
10 seconds after starting, the „charge" leD (20)
will light up and the charging voltage will be at the
preset lowest charging rate�
If the battery is recognised to be defective or
connected with the poles reserved the "error" (21)
or "bad battery" (22) leD will light up� In this case,
unplug the charger and check the battery and the
correct connection (also see "Troubleshooting")�
4� Verify the device's preset charging voltage
(12 V or 24 V) corresponds with the connected
battery� If the charging voltage is too high, the
connected battery may be damaged/destroyed�
5� you may repeatedly press the MoDe button
(29, 30) during charging to select the charging
voltage and the charging current (see „charging
current")�
6� Whilst charging you can press the TyPe button
(28) several times to select the battery type (see
„switching battery Types")�

Start charging

1� repeatedly press the TyPe (28) button to select
the battery type� The leD (15, 16, 18) indicates
the selection�
2� repeatedly press the MoDe (29) button to
select the respective charging current 12 V or 24
V� The leD (14, 15) indicates the selection�
3� repeatedly press the MoDe (30) button to
select the respective charging current� The leD
(10, 11, 12) indicates the selection�
4� Press (27) button to start charging� The
"charge" (20) leD will light up throughout the
charging process�
5� The battery is fully charged when the "charge"
(20) leD goes out� The display indicates the
battery condition as 100 % and the "full" (19)
leD lights up�