Product Overview; Operation; Before Use; Connecting The Device - AEG LG 8 Bedienungsanleitung

16 www.aeg-automotive.com
ProDucT
oVerVIeW
9
8
7
6
5
4
3
No. Description
charging speed selector
1
left position: quick charging
right position: gentle charging
2
red "PolarITy" leD
3
Green "PoWer" leD
4
amber "cHarGInG" leD
5
Green "full" leD
6
charging cable (-) with charging clamp (black)
7
charging cable (+) with charging clamp (red)
8
Power cable with plug
battery selector switch
9
left position: lead-acid batteries
right position: Gel batteries

oPeraTIon

Before use

Warning!
before using this device be sure to read the ope-
1
rating manual for the battery and the vehicle and
understand all safety notices�
•
use safety goggles and acid-proof safety gloves�
•
ensure adequate ventilation�
•
ensure the battery poles are clean� If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
2
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed�

Connecting the device

always verify the charging device is disconnected
from the 230 V ac outlet when connecting to a
battery�
1� connect the red (+) terminal connection cable
with clamp (7) to the positive battery terminal�
2� connect the black (-) terminal connection cable
with clamp (6) to the negative battery terminal�
note:
The black (-) clamp can also be connected to the
vehicle chassis (Please refer to the auto maker's in-
structions!)� be sure both clamps have good contact
and are securely seated�
Warning!
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable� In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable�
3� Plug the charger plug into a 230 V power socke�
If incorrectly connected to the battery (reverse
polarity) all four leDs will light up and charging
won't start�