Operation; Before Use; Connecting The Device; Start Charging - AEG LI 7 Bedienungsanleitung

22 www.aeg-automotive.com

OPERAtION

Before use

Warning!
Before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices.
•
Use safety goggles and acid-proof safety gloves.
•
Ensure adequate ventilation.
•
Ensure the battery poles are clean. If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.

Connecting the device

1. Connect the requi-
red terminal con-
nection cable (with
rings or clamps) to
the device's comfort
plug connection (3).
2. Connect the red
(+) pole connec-
tor cable to the
positive pole of the
battery.
3. Connect the black
(-) pole connec-
tor cable to the
negative pole of the
battery.
Note:
The black (-) clamp can also be connected to the
vehicle chassis (Please refer to the auto maker's in-
structions!). Be sure both clamps have good contact
and are securely seated.
Warning!
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable. In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable.
4. Plug the charger plug into a 230V power socke.
If the charger is connected correctly, the "Power"
LED (12) will light up. In this mode the charger will
automatically reset to the default settings.
If the battery is recognised to be defective or
connected with the poles reversed, the "Error" LED
(9) will light up. In this case, unplug the charger and
check the battery and the correct connection (also
see "Troubleshooting").

Start charging

1. Repeatedly press the „V" button (1) to select the
desired charging mode, 6 V or 12 V. the LED will
indicate your selection.
Note:
If an incorrect charging mode was selected, the
"Error" LED (9) will light up. In this case unplug the
6 V 12 V
V
3,5 A 7 A
V A %
charger, wait briefly, and plug in again.
V/A/%
2. the charging process will start automatically.
7 A
the "charge" LED (11) will light up throughout
the charging process.
3. the battery is fully charged when the "Full" LED
(10) lights up and the "Charge" LED (11) goes
out.
Note:
Once the battery is fully charged, the charger will
switch to trickle charge to maintain the charging
status and protect the battery from overcharging
•
the display will show 100 and the LED „%" will
light up.
•
Use the „V / A / %" (2) button to switch the dis-
play during charging (see "Product overview").