As soon as the radiator thermostat has been taught
in to the cube, all data such as date, time or weekly
program are transmitted to it via the radio connec-
tion.
Without a cube, the radiator thermostat can only be
used in manual mode; it cannot be switched to au-
tomatic operation.
The radiator thermostat can only be taught-in on one
cube.
If the radiator thermostat has already been config-
ured with a wall thermostat, a factory reset must be
performed prior to teaching-in for the first time to a
cube (see section 9).
The radiator thermostat can be reset to the initial state
manually. Restoring the initial state deletes all settings and
information about taught-in devices.
• First remove the batteries from the actuator.
• Wait 60 seconds.
• Press and hold down the three buttons (Auto/Manu,
Boost, (
• Re-insert the batteries.
• Once the factory settings have been restored success-
fully, "rES" is displayed.
9. Teach-out/Reset
)) afterwards.
41