Teach-Out / Reset (Res) - eQ-3 MAX! Bedienungsanleitung

The initial state of the MAX! Wall Thermostat + can be res-
tored manually, e.g. to teach-in a single MAX! Room Solu-
tion to a MAX! Cube or to re-install an incorrectly operating
system. Restoring the initial state deletes all settings and
information about taught-in devices.
In the MAX! House Solution, first delete the device
from the MAX! software before restoring the fac-
tory settings.
In the MAX! Room Solution, the factory settings of
the MAX! Wall Thermostat + are restored as follows:
• Press the Menu button for more than 3 seconds.
• Select the "rES" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• The display will show "ACC", confirm restored factory
settings with the OK button.
If your MAX! Wall Thermostat + is taught-in to a MAX!
Cube, the configuration menu on the device will be
locked. You can still restore the factory settings as
follows:
• Remove a battery and wait for 60 seconds.
• Press and hold down reduce ( ), OK and the - button
simultaneously and insert the battery at the same time
• When „rES" appears on the display, the reset was per-
formed and the buttons can be released.
• You can now start to make the setting.
56

17. Teach-out / Reset (rES)