Safety Instructions - Endress+Hauser Promag 100 Einbauanleitung

EA01249D
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
5

Safety instructions

• Only use original parts from Endress+Hauser.
• Comply with national regulations governing mounting, electrical installation,
commissioning, maintenance and conversion procedures.
• The specialized technical staff involved in the mounting, electrical installation,
commissioning, maintenance and conversion of the measuring devices must meet the
following requirements:
– Specialized technical staff must be trained in instrument safety.
– They must be familiar with the individual operating conditions of the devices.
– In the case of Ex-certified measuring devices, they must also be trained in explosion
protection.
• The measuring device is energized! Risk of fatal injury from electric shock. Open the
measuring device only when the device is deenergized.
• When using Ex-certified measuring devices: Open device only when in a deenergized state
(allow 10 minutes to elapse after switching off the power supply) or in environments which
do not have a potentially explosive atmosphere.
• For measuring devices in safety-related applications in accordance with IEC 61508 or
IEC 61511: Following conversion, re-commission device in accordance with Operating
Instructions. Document conversion.
• Before removing the device: set the process to a safe state and purge the pipe of dangerous
process substances.
• Hot surfaces! Risk of injury! Before commencing work: Allow the system and measuring
device to cool down to a touchable temperature.
• In the case of devices in custody transfer, the custody transfer status no longer applies once
the seal has been removed.
• The Operating Instructions for the device must be followed.
• Risk of damaging the electronic components! Ensure you have a working environment
protected from electrostatic discharge.
6
Order code Description
3.
=
?
4.
1. www.endress.com/deviceviewer
2. Enter the serial number of the modification kit,
search for the product data and click "Order code".
3. The order structure of the modification kit is
displayed.
4. Check the order number of the modification kit.
• Check the serial number against the serial number of
the original device.
• Does the configuration of the modification kit match
the ordered configuration?
= YES, the modification kit may be used for the
measuring device.
= NO, the modification kit may not be used for the
measuring device.
Endress+Hauser