Intended Use; Technical Data; Technical Details; Tailstock - Drechselbedarf Midi FU -350 Bedienungsanleitung

2. Intended use

The lathe FU-350 is designed for hobbyists and for semi-professional turning work (max. 6 hours continuous
operation a day) in the interior and constructed to handle wood, horn, bone and plastics in smaller sizes. The
processing of other materials is not permitted or may only be made in special cases after consultation with
the machine manufacturer. The lathe shall be used exclusively for longitudinal and face turning of round or
regularly shaped prismatic workpieces.
The lathe is not suitable for use in explosive environments.
Improper use of the machine can lead to a risk to human and
tangible assets, also the function of the machine can be compromised.
If the turning machine is used any other than mentioned above, shall be deemed as being not in conformity
with the intended purpose. For resulting damage we do not assume any liability as manufacturer.

3. Technical details

Measurements
Length x height x depth ............................................................................................ 865 x 330 mm x 415 mm
Handles ...............................................................................................................................................2 pieces
Weight
Total weight.............................................................................................................................................. 43 kg
Distance between centers
Hight of centers
Headstock
Spindle thread ........................................................................................................................... M33 x 3.5 mm
Drilling....................................................................Morse taper MK 2 with 10 mm through-hole by headstock
Part Set-Up .................................................24-step (every 15 degrees) with reading scale on the handwheel
Spindle lock by locking with the enclosed ejector rod ..............................................................................twice
Drive
..........................................................~ 230V, three-phase motor, IP54, 1,420 revs / min 50 Hz 750 W
..............The control of the motor speed is infinitely variable by the potentiometer on the mobile control box.
Mains connection
Speed levels (revs / min at the spindle) ...... .... ..................... .Stufe I 80-800 revs / min, stage II 170-1700
.................................................................................... and stage III 360-3700 revs / min by adjusting the belt

Tailstock

Drilling.......................................................................................... Morse taper MK 2 with 10 mm through hole
Quill travel...................................................................................................... 50 mm with measurement scale
Knife support
............................................................................................. 150 mm with 1» (25,4 mm) pin
Emission sound pressure level
© Drechselbedarf Schulte
........................................................................................................ 350 mm
.....................................................................................175 mm / (workpiece Ø 350 mm)
...............................................................................................230 V ~ 1 / N / PE 50 Hz
......................................................................................... <79 dB (A)
Original Operating Instructions V1.0 - 7 -