Requirements For The Set-Up Location - Drechselbedarf Midi FU -350 Bedienungsanleitung

6.

Requirements for the set-up location

Requirement
Set-up location of the lathe Place the Midi FU - 350 in a dry interior close to a power source (mains).
Lighting and ventilation
Electrical equipment
Ventilation
Working height
Working space
Base unit
© Drechselbedarf Schulte
Recommendation
Watch out for flat, firm and stable surface.
Allow sufficient space in front of the machine as a workspace.
Other established machines in the workshop shall not affect the operation of
the lathe.
Make sure that there is a good light (illuminance levels according to DIN5035)
and ventilation. Additionally use an adjustable lighting system for your works-
pace on the lathe, so that no shadows will be thrown on the workpiece. We
recommend the establishment of a light source which worth at least 300 LUX,
better has a 500 LUX on the cutting edge.
If possible, place the machine near a window.
A suitable standard household 230 V socket which is fused with 16 amp. is
required to operate the lathe.
Electrical cables and sockets must comply with local electrical regulations.
If in doubt, ask your professional electricians. Avoid the use of an extension
cord (see also the chapter « Connection of the lathe to the power supply»).
Ventilate your workplace sufficiently. The degree of ventilation depends on the
size of the workshop and the number of finished workpieces. The use of dust
extraction systems and filters reduce your health risk.
The lathe should be located such that the spindle center position is at the
height of the operators elbow.
Before the lathe shall be a free space of at least 80 cm.
Since the MIDI FU-350 is a benchtop, the operator has to ensure to use a pro-
per installation space or a suitable base unit. Your dealer offers a base unit.
The provided 3/8 «x 50 mm screws can be firmly connected to a base unit
instead of using the feet.
Original Operating Instructions V1.0 - 11 -