Maintenance; Replacement Of Control Unit Fuse; Discarding Instructions - Nouvag MD20 Bedienungsanleitung

NOUVAG AG

8.1 Replacement of control unit fuse

Defective control unit fuses can be replaced by the user without outside help. They can be found at the
back of the device in the fuse compartment next to the main switch:
1) Plug out mains cable.
2) Open fuse compartment with a screw driver.
3) Replace defective fuse T 2A.
4) Insert fuseholder again and close fuse compartment.
5) Check displayed mains voltage on fuse compartment.
6) Plug back mains cable.

8.2 Discarding instructions

When discarding the device, device components and accessories, please comply with the issued
statutory regulations.
With regard to the preservation of the environment old equipment may be returned to the distributor or
manufacturer.
No. 31842 14/06

8 Maintenance

1. Displayed mains voltage
2. Fuse compartment
3. Clasp fuse compartment
4. Fuse 1
5. Fuse 2
MD20
15