Maintenance; Blade Roll; Information On Disposal - Nouvag Mesher Bedienungsanleitung

9

Maintenance

9.1

Blade roll

Depending on the load, the blades of the blade roll are subject to wear. The blades have to be exchanged
when the cutting quality slowly declines. If only a few blades are defect, due to accidently have the blade
roll fallen down, the blades can all be changed separately.
Replacing the blade roll:
•
Remove the ratchet and hinge the bridge up to the stop.
•
Remove blade roll and dispose of properly. Insert new blade roll and close bridge.
•
Lock the bridge by turning the clamping wing pair towards each other. The notches point down and are
not visible anymore.
● Don't lay the blade roll on hard surfaces, the blades may be damaged!
● Do not resharpen the blades. The cutting precision will be lost and the backpressure may be lost due to
reduced diameter of the blades.
9.2

Information on disposal

When disposing of devices, device parts and accessories, the regulations prescribed by law must be
observed.
Do not dispose of devices with household waste. To ensure environmental protection, old devices can be
returned to the dealer or manufacturer.
Contaminated single use mesh boards are subject to specific disposal requirements.
Please observe currently valid national disposal regulations for infectious waste.
12
Turn clamping wing pair oppositely, until the notches are visible from the
top. The bridge locking is now open.
Operating instructions Mesher, Ref. 31584, V32/15
Mesher, skin expansion system