Monitor Function; Selection Of Transmission Power - Midland G12 Bedienungsanleitung

2 Restricted traffic mode does not guarantee privacy of
communication. Indeed, when using CTCSS/DCS, anyone
operating in open traffic mode can hear your conversation, they
cannot however take part, as they would not be heard from you.
2 Restricted traffic mode allows the use of the same radio frequency
by more than one group. For example, group A using CTCSS No.
16 tone will not hear conversations of group B who uses CTCSS
No. 20 tone and vice versa. However, if more than one user
transmits at the same time (e.g. one user from group A together
with one user from group B) on the same channel, there will be
interference. For this reason do not transmit if the radio signals
that the channel is busy even if you do not hear anything, waiting
instead for it to be free. If in doubt use the monitor function.
2 If you have to use MIDLAND G2 in the proximity of electrical
equipment which generates electrical noise causing the squelch
to open frequently, it is advisable that you use the restricted traffic
mode.

5.8 Monitor function

In order to listen for extremely weak signals, as explained in par. 5.6.b,
the circuit which silences audio reception (squelch) is automatically
turned off as soon as you receive a signal. However extremely poor
signals may not trigger it to switch off and, as a consequence of this,
you will hear broken conversation. In this case the function monitor
will help by disabling temporarily the squelch.
Moreover if the channel you are using has been programmed to
operate in restricted traffic (ref. par. 5.7), with the function monitor
you can temporarily disable CTCSS or DCS in order to monitor all
6
communication on the channel you are tuned in.
In order to activate the function monitor, keep press the SCAN/MON
button for about three seconds until you hear a faint background
noise (or eventually the weak signal).
In order to disable the monitor function, repeat the operation.
2 Do not use the monitor function for too long as this will use up the
battery. The energy saving function (ref. par. 5.6.a) functions only
when the audio of your device is silenced (squelch enabled).

5.9 Selection of transmission power

The transmission phase absorbs the most energy. To extend the
battery duty, you can select low transmission power when transmitting
over short distances. When low transmission power is activated
will appear on the display. To select low transmission power:
1) Press six times the MENU button. The display shows Po (power of
transmission) followed by Lo (low) or Hi (high) flashing according
to the pre-set values.
2) Press buttons + o – until you have selected the desired power.
3) Press PTT button to exit, or wait for few seconds. The device will
go back to standby mode storing the new value set.
2 If you are transmitting to someone who is nearby, try always low
power of transmission. In this way you will extend battery life
and reduce the risk of being heard by others outside your line of
communication.