Midland G12 Bedienungsanleitung Seite 28

Problem Possible cause
Reception is broken and/or Extremely weak signal
disturbed
The other party is too far and/or transceiver is out of
reception because of obstacles in the direction of the
other party
Others are using the same radio channel
Radio positioned too near devices which could cause
interference such as television, computer etc.
Some times it is not possible to Channel too busy and Busy Lock Out enabled
transmit
Timeout timer is active
VOX makes the radio transmit Excessive sensitivity or loud ambient noise
accidentally
It is necessary to speak loudly Sensitivity too low
with VOX active
Battery charge lasts too little Excessive use of transmission
Excessive use of vibration alert
Memory effect of batteries
Malfunctioning in the logic of Wrong setting caused by some anomalies in the
the device (conflicting symbols current supply
on the display, functions do not
work, etc.)
Solution
Try to disable squelch temporarily using the monitor
function
Move closer to other party or move to more favourable
spot
Check out the radio traffic on the channel you are using
with monitor function and eventually change channel
Move the radio further away from interfering device.
Change channel or disable transmission.
Shorten transmission time or lengthen timeout timer
Lower VOX sensitivity
If ambient noise is not excessive put sensitivity level
higher or make use of an optional microphone
Try to reduce transmission time and/or utilise low power
of transmission
Disable vibration alert
Stop memory effect
Carry out reset procedure
5.8
-
5.8
-
6.6
6.8
6.2.a
6.2.b
5.9
6.4
4.4
9.2
27