Keypad Lock; Enabling/Disabling Roger Beep - Midland G12 Bedienungsanleitung

5.0 Keypad lock

During normal use you can lock the transceiver's keypad in order to
avoid accidental activation of any function.
To activate the keypad lock, hold down the CALL/LOCK button
for about three seconds until the symbol appears on the display
(bottom right). This will deactivate all buttons of the transceiver
except transmission (PTT button), call (CALL/LOCK button) and the
monitor (SCAN/MON button - ref. par. 5.8). Any attempt to access
the disabled buttons while in this mode will cause an audio error
signal (low tone).
To deactivate the keypad lock keep the CALL/LOCK button pressed
for about three seconds until the symbol disappears.
2 It is not possible to lock the keypad when the device is scanning
or in Dual watch mode.
5. Audio call function
You can send an audio call on the selected channel. You can do this
by pressing briefly the CALL/LOCK button. Your device will stay in
transmission mode for two seconds, broadcasting the call (to attract
the attention of the other party) and then it automatically goes back
to reception.
2 During transmission of the call the speaker of your device will also
play the call melody as confirmation.
2 You can select any of the 10 preset melodies.
2 Audio call is a special feature of MIDLAND G2. For this reason it
is advisable to warn and check with the other party about it so that
unnecessary interferences may be avoided.
5.11.a Silent calls
If you are communicating with another MIDLAND G2, you can carry
out silent calls! To do this, you enable the vibrating alert on your
device as described in par. 6.4. Once you have switched to vibrating
alert, every time you receive a call from another MIDLAND G2, your
device will alert you of the call by vibrating but it will remain silent.
2 Silent call is a special feature which works only among MIDLAND
G12.
5.2 Enabling/disabling keypad tones
Keypad tones are emitted each time a button is pressed in order
to reduce the likelihood of accidentally pressing a button twice.
This option can be deactivated if you prefer the radio to be silent.
To activate or deactivate keypad tones, carry out the steps outlined
below:
1) Turn off your device.
2) Keep the – button pressed and turn the device back on. All
symbols on the display light up for about one second and you
hear a beep sound of confirmation.
3) When the display comes back to its normal status, release the
– button. The keypad tones will be disabled.

5.3 Enabling/disabling roger beep

"Roger beep" is a brief tone which your radio gives out at the end of
every transmission as soon as you release the PTT button. This is
to avoid that saying 'roger' every time you finish talking. In order to
enable/disable the roger beep do the following:
1) Turn off your device.
7