Midland G12 Bedienungsanleitung Seite 21

6.2.a Settings of internal VOX
If you use the device on its own, you can enable the internal VOX and
optimise its functioning by registering its sensitivity according to the
following instructions
1) Press the MENU button three times. The display shows the
icon followed by I (internal VOX). On the left the current VOX
setting flashes (E.g. 0).
2) Press the button + or – to select the number corresponding to the
desired setting according to the following table:
No. Sensibility Notes
0 - Internal VOX disabled
 Minimal You will need to speak up and talk near the
radio, however you will be able to operate even
in noisy environment
2 Medium Medium setting
3 Maximum You will be able to speak normally without
raising the volume of your voice and at a
greater distance from the radio. However, if the
environment is not sufficiently quiet, a noise
could accidentally initiate transmission
3) Press the PTT button to exit or wait for a few seconds. The device
will go back to standby mode storing the new setting. If you keep
the device nearby (e.g. on your desk) you can now talk hands
free
6.2.b Settings of external VOX
If you are using external microphone + headphones, you can enable
external VOX. To optimize settings do the following:
20
1) Turn off the radio.
2) Remove the rubber cover which protects SPK and MIC/CHG
connectors.
3) Insert headphones and microphone jacks into sockets SPK e
MIC/CHG and wear your microphone as close as possible to the
side of your mouth.
4) Switch on the radio. Before installing the accessory bring the
deviating switch on VOX.
5) Press the MENU button four times. The display shows the icon
followed by E (external VOX). On the left the current VOX setting
flashes ( E.g. 0):
No. Sensibility Notes
0 - External VOX disabled
 Minimal
You will need to speak up, however you will be
able to operate even in noisy environment
2 Medium Medium setting
3 Maximum You will be able to speak normally without
raising the volume of your voice. However, if
the environment is not sufficiently quiet, a noise
could accidentally initiate transmission
6) Follow steps 2 and 3 described in par. 6.2.a. At this point you can
operate hands free in complete freedom of movement.
! When you have finished using external audio accessories do
not forget to replace the rubber cover protection onto the
sockets.
! Connection or disconnection of audio accessories must
always be carried out with the radio turned off.