Preparing To Inhale; Assembling The Nebuliser; Filling With Medication - Pari LC SPRINT SINUS Bedienungsanleitung

4

Preparing to inhale

- Before the device is used for the first time, before it is re-used,
and after any long break in use, please follow the hygiene
regulations.
- Ensure that the nebuliser was cleaned, disinfected, and, if appro-
priate, sterilised after the last treatment (see Chapter 6 "Hygienic
re-use").

4.1 Assembling the nebuliser

Figure A:
The individual nebuliser parts are assembled as follows:
• Gently push the nozzle attachment (1b) as far as it will go onto the nozzle
in the nebuliser lower section (1c) of the PARI LC SPRINT SINUS neb-
uliser.
The arrow on the nozzle attachment must point upwards.
• Place the nebuliser upper section (1a) on the nebuliser lower section and
turn it clockwise to lock the two parts together.
• Connect the nasal joining piece (4) to the knee (3) and insert the other end
of the knee in the nebuliser upper section (1a).

4.2 Filling with medication

Figure A:
• Release the closure on the nebuliser upper section (1a) of the PARI LC
SPRINT SINUS nebuliser by pressing your thumb against the underside of
the cap (see Figure B).
Take care to ensure that the cap only moves in the direction
allowed by the hinge.
• Pour the quantity of medication prescribed by your doctor into the nebuliser
funnel (see Figure C).
Ensure that the medication is filled no higher than the upper scale marking
(max. level 8ml). If you overfill the nebuliser and the medication leaks out
EN
23