At Home - Pari LC SPRINT SINUS Bedienungsanleitung

6.3 At home

6.3.1 Cleaning
• Dismantle the nebuliser (see Chapter 6.2 "Preparation").
Recommended method: Use warm tap water
• Clean all parts of the nebuliser thoroughly for 5 minutes with warm tap
water (approx. 40°C) and a little dishwashing liquid (dosage according to
the manufacturer's recommendations).
• Then rinse all parts thoroughly under warm running water (approx. 40°C
without dishwashing liquid).
• Drain off well.
You can remove excess water more quickly by shaking the parts.
Possible alternative: Wash in the dishwasher
• Clean the nebuliser in your dishwasher (not together with dirty crockery).
• Distribute the nebuliser parts in the cutlery basket.
• Select a programme of at least 50°C.
6.3.2 Disinfection
Disinfect the dismantled nebuliser after cleaning.
Recommended method: Use the NUK Vaporisator 6 (part no. 500G2000)
or the Petra disinfector DI 6.00 (part no. 041G6000)
Be sure to follow the instructions for use of the NUK Vaporisator 6 and the DI
6.00 disinfector. The treatment time is about 15 minutes.
Possible alternative: In boiling water
• Place the individual parts of your nebuliser in boiling water for at least 15
minutes. If your local tap water is hard, please use low-lime or distilled
water.
Ensure that the water level in the pot remains high enough to prevent the neb-
uliser parts from coming into contact with the hot base of the pot.
6.3.3 Drying
• Place the nebuliser parts on a dry, clean and absorbent surface and let
them dry completely (at least 4 hours).
6.3.4 Storage
• Between uses, and in particular during long breaks in treatment, wrap the
nebuliser in a clean, lint-free cloth (e.g., a tea-towel) and keep it in a dry,
dust-free environment.
EN
29