Dismantling And Disposal - GCE druva VPLDSMAR Gebrauchsanleitung

DISMANTLING AND DISPOSAL

10.
Once the system has reached its end-of-life, it must be dismantled and disposed of in an environmentally
compatible way.
10.1 SAFETY NOTES FOR DISMANTLING AND DISPOSAL
WARNING!
•
Risk of injury through incorrect dismantling!
RESIDUAL ENERGY STORAGE, SHARP EDGED COMPONENTS, TIPS AND CORNERS ON AND IN THE
SYSTEM OR ON THE REQUIRED TOOLS CAN CAUSE INJURY.
•
arrange enough space for working
•
be careful with sharp edges
•
pay attention for order and cleanness
•
loose components can cause accidents
•
dismantle the components properly. Bear in mind that some of the components are heavy. Use lifting
equipment if necessary
•
secure the components against falling or toppling over
10.2 DISMANTLING
PRIOR STARTING DISMANTLING
Depressurize the shut-off valve by turning the handwheel 90°.
Depressurize tubing system.
Dismantle the assemblies and components properly and in compliance with applicable local work safety and
environmental protection regulations. environmental protection regulations.
At the end devices and components have to be cleaned and disassembled due to valid rules of industrial
safety and environment protection.
10.3 DISPOSAL
In the absence of a return or disposal agreement, the dismantled components should be recycled as follows:
Metals: scrap.
Plastics: recycle.
Other components: sort and dispose.
NOTE!
•
Risk of environmental harm through incorrect disposal!
•
Incorrect disposal can harm the environment.
•
Commission a specialized licensed firm to dispose of electrical waste, electronic components, lubricants
and other auxiliary materials.
•
If in doubt, enquire how to ensure environmentally compatible disposal at your local council office or
consult a specialist disposal firm.
GCE s.r.o.
Zizkova 381
583 81 Chotebor
Czech Republic
Tel: 00 420 569 661 111
Fax: 00 420 569 661 602
http://www.gcegroup.com
© GCE s.r.o.
17/36
EN