Evaluating Results - Beurer BC 57 Gebrauchsanweisung

The blood pressure monitor will begin the measurement
automatically after 5 seconds.
The measurement is taken during the inflation phase.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
played.
• The systolic pressure, diastolic pres-
sure and pulse rate measurements
are displayed.
• EE_ appears if the measurement could not be per-
formed properly. Observe the chapter on
error messages/troubleshooting in these
instructions for use and repeat the meas-
urement.
• Now select the desired user memory by pressing the
memory button M. If you do not select a user memory,
the measurement is stored in the most recently used
user memory. The relevant symbol M1 or M2 appears
in the display.
• Press the START/STOP button
blood pressure monitor. The measurement is then
stored in the selected user memory.
If Bluetooth
ferred after pressing the START/STOP button
The Bluetooth
pressure monitor now attempts to connect to the app for
. approx. 30 seconds.
is dis- The Bluetooth
nection is established. All measurement data is automati-
cally transferred to the app. Once the data has been suc-
cessfully transferred, the device switches off.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth
blood pressure monitor switches off automatically after
3 minutes.
• If you forget to turn off the device, it will switch off auto-
matically after a maximum of 3 minutes. In this case
too, the value is stored in the selected or most recently
used user memory.
• Wait at least 5 minutes before taking an-
other measurement.

6. Evaluating results

Cardiac arrhythmia:
This device can identify potential disruptions of the heart
rhythm when measuring and if necessary, indicates this
after the measurement with the symbol
to switch off the
This can be an indicator for arrhythmia. Arrhythmia is an
illness in which the heart rhythm is abnormal because of
® data transfer is activated, data is trans-
® symbol flashes on the display. The blood
® symbol stops flashing as soon as a con-
symbol goes out and the
®
30
.
.