Electrical Warnings - IKEA FROSTIG Anweisungen

ENGLISH
Keep children away from the installation site.
After unpacking the appliance, make sure that
it has not been damaged during transport.
In the event of problems, contact the dealer
or your nearest Aftersales Service. Once
installed, packaging waste (plastic, styrofoam
parts etc.) must be stored out of reach of
children - risk of suffocation. The appliance
must be disconnected from the power supply
before any installation operation - risk of
electrical shock. During installation, make sure
the appliance does not damage the power
cable - risk of fire or electrical shock. Only
activate the appliance when the installation
has been completed.
Be careful not to damage the floors (e.g.
parquet) when moving the appliance.
Install the appliance on a floor or support
strong enough to take its weight and in a
placesuitable for its size and use. Make sure
the appliance is not near a heat source and
that the four feet are stable and resting on the
floor, adjusting them as required, and check
that the appliance is perfectly level using a
spirit level. Wait at least two hours before
switching the appliance on, to ensure that the
refrigerant circuit is fully efficient.
WARNING: To avoid a hazard
due to instability, positioning
or fixing of the appliance must
be done in accordance with the
manufacturer instructions.
Warning: It's forbidden to place the
refrigerator in such way that the metal hose
of gas stove, metal gas or water pipes,
or electrical wires are in contact with the
refrigerator back wall (condenser coil).

ELECTRICAL WARNINGS

It must be possible to
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream
of the socket and the appliance
must be earthed, in conformity
with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical components
must not be accessible to the user after
installation. Do not use the appliance when
you are wet or barefoot. Do not operate this
appliance if it has a damaged power cable
or plug, if it is not working properly, or if it
has been damaged or dropped. If the power
cable is damaged, it must be replaced with an
identical one - risk of electrical shock.
If the supply cord is damaged,
it must be replaced with an
identical one by the manufacturer,
its service agent or similarly
qualified persons in order to avoid
a hazard - risk of electrical shock.
Make sure the voltage
specified on the rating plate
corresponds to that of your home.
Do not store explosive
substances such as aerosol cans
with a flammable propellant in this
appliance.
Do not store or use petrol, flammable
liquids or gas in the vicinity of this or other
electrical appliances. The fumes can cause
fires or explosions.
Feets of the product: in Fs not
available;in built in - the "feet are
not adjustable - and the METOD
cabinet should be levelled with
spririt level.
Do not pull the appliance
power cable.
6