Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Warnings - IKEA FRYSA AA-2242711-2 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
the appliance on a floor or support strong
enough to take its weight and in a place
suitable for its size and use. Make sure the
appliance is not near a heat source and that
the four feet are stable and resting on the
floor, adjusting them as required, and check
that the appliance is perfectly level using a
spirit level. Wait at least two hours before
switching the appliance on, to ensure that
the refrigerant circuit is fully efficient.
WARNING: When positioning the
appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to
instability, positioning or fixing of the
appliance must be done in accordance
with the manufacturer instructions. It's
forbidden to place the refrigerator in such
way that the metal hose of gas stove, metal
gas or water pipes, or electrical wires are
in contact with the refrigerator back wall
(condenser coil).
To guarantee adequate ventilation, the
distance between the rear of the appliance
and the wall behind the appliance should
be 50 mm, to avoid access to hot surfaces.
A reduction of this space will increase the
Energy consumption of product. Please
remove the power cord from condenser
hook during installation before connecting
product to power supply.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has a
damaged power cable or plug, if it is not
working properly, or if it has been damaged
or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
- risk of electric shock.
WARNING: Do not locate multiple
portable socket-outlets or portable power
supplies at the rear of the appliance.
Feets of the product: in Fs not available;
in built in - the "feet are not adjustable - and
the METOD cabinet should be levelled with
spririt level.
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis