Electrical Warnings; Cleaning And Maintenance - IKEA TINAD RÅKALL Bedienungsanleitung

ENGLISH
of reach ofchildren - risk of suffocation.
The appliance must be disconnected from
the power supply before any installation
operation - risk of electric shock.
During installation, make sure the
appliance does not damage the power
cable - risk of fire or electric shock.
Only activate the appliance when the
installation has been completed.
Be careful not to damage the floors
(e.g.
parquet) when moving the appliance.
Install theappliance on a floor or support
strong enough totake its weight and in a
place suitable for its sizeand use. Make
sure the appliance is not near a heat
source and that the four feet are stable
and restingon the floor, adjusting them
as required, and checkthat the appliance
is perfectly level using a spiritlevel. Wait
at least two hours before switching
the appliance on, to ensure that the
refrigerant circuit is fully efficient.
WARNING: When positioning the
appliance,ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to
instability,positioning or fixing of the
appliance must be done
in accordance with the manufacturer
instructions. It's forbidden to place the
refrigerator in such way that the metal
hose of gas stove, metal gas or water
pipes, or electrical wires are in contact with
the refrigerator back wall (condenser coil).
All dimensions and spacing needed for
installation of the appliance are in the
Installation Instruction booklet.
Please remove the power cord from
condenser hook during installation before
connecting product to power supply.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if it is
not working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard - risk of electric shock.
WARNING: Do not locate multiple
portable socket-outlets or portable power
supplies at the rear of the appliance.

CLEANING AND MAINTENANCE

WARNING: Ensure that the appliance
is switched off and disconnected from
the power supply before performing any
maintenance operation. To avoid risk
of personal injury use protective gloves
(risk of laceration) and safety shoes (risk
of contusion); be sure to handle by two
persons (reduce load); never use steam
cleaning equipment (risk of electric
shock). Non-professional repairs not
authorized by the manufacturer could
result in a risk to health and safety, for
which the manufacturer cannot be held
liable. Any defect or damage caused from
non-professional repairs or maintenance
will not be covered by the guarantee,
the terms of which are outlined in the
document delivered with the unit.
Do not use abrasive or harsh cleaners
such as window sprays, scouring
cleansers, flammable fluids, cleaning
waxes, concentrated detergents, bleaches
or cleansers containing petroleum
products on plastic parts, interior and door
liners or gaskets. Do not use paper towels,
scouring pads, or other harsh cleaning
tools.
7