Reely Free Men Bedienungsanleitung Seite 34

Assembly drawing 19:
First mount the stabilisation rod using both of the M3 x 15 screws. Then the steering linkage (D) and the tie rod (C)
can be mounted.
Assembly drawing 20:
When mounting the shock absorbers, make sure that the adjusting screw is always on top of the shock absorber.
Assembly drawing 21:
The diagrams show the assembly of the gear. Both parts of the gear housing are marked with identifying letters "A"
and "B" on the inside.
Assembly drawing 22:
Apply some grease to the gears before closing and screwing shut the gear housing.
Assembly drawing 23:
Figure 23 shows the assembly of the gears for the reversing gear. This gear stage allows both cardan shafts to run
in different directions.
Assembly drawing 24:
Firstly, insert the two hexagonal friction surfaces precisely into the main gear and then put on the cover discs. Then
screw the coupling unit together with the shaft. In doing so, keep the exact distance of 1.2 mm so that the coupling
does not slip too early or too late.
Assembly drawing 25:
Firstly, mount the electric motor and tighten the screws so that the motor can still be moved laterally. Push the motor
gear onto the motor shaft until it is flush with the main gear. The M4 stud screw must be aligned with the flattened side
of the motor shaft. The teeth of both gears must also mesh with one another throughout the width (see also Figure 4
below in this manual).
Then place a thin paper strip between the gears and press the motor gear against the main gear. Screw the motor
tightly in this position. After removing the paper strip, the distance between the two gears and thus the backlash are
set correctly. Then screw on the cover.
Assembly drawings 26 and 27:
Apply some thread-locking fluid to the cardan shaft bolt (A) before screwing it in. Note that the cardan shafts are dif-
ferent lengths. Therefore, make sure that they are correctly mounted.
Assembly drawing 28:
When mounting the gear, note that the screws are different lengths and make sure that they are correctly positioned.
Assembly drawing 29:
When mounting the left side part, make sure that the front M2.5 x 10 screw has a smaller diameter.
34