General Description; Scope Of Delivery; Function Description; Summary - Parkside PSBS 240 C2 Originalbetriebsanleitung

The manufacturer shall not be liable for
damages caused by use other than for the
intended purpose or by incorrect opera-
tion.

General description

The illustrations can be found
on the front and rear fold-out
pages.

Scope of delivery

Unpack the equipment and check that it is
complete. Dispose of the packaging mate-
rial correctly.
- Appliance
- Transparent spark protection (
- Adjusting screw for spark protection
( 2) (1 cross-drive screw incl. spring
washer and washer as well as nut)
- 2 workpiece supports (
mounting material (2 star grip nuts
( 5/17), 2 screws, 2 washers,
2 toothed lock washers
- 2 x Grinding belt
(1 x P* 80, 1 x P* 120)
- Instruction Manual
* Grit size (of the grinding belt)

Function description

The bench grinder with belt sander is a
combined device equipped with a grind-
ing disc and an adjustable grinding belt.
The device is provided with a spark pro-
tection and protective hoods for the protec-
tion of the user.
For the function of the operating parts,
please refer to the descriptions below.

Summary

1)
6/18) with

Technical specifications

Bench Grinder
with belt sander ................... PSBS 240 C2
Nominal input voltage U ... 230 V~, 50 Hz
Power consumption P ..240 W (S2 30 min)*
Safety class .......................................... I
Mechanical rating ............................IPX0
Measurement idling speed n
Grinding disc
Outer diameter ................... Ø 150 mm
Bore hole .......................... Ø 12.7 mm
1 Spark protection (two-piece)
2 Adjusting screw for spark protec-
tion
3 Protective hood grinding disc
4 Engine housing
5 Star grip nut to install the work-
piece support grinding belt
6 Workpiece support grinding belt
7 Clamping lever grinding belt
8 Adjusting screw for belt run
9 Protective hood grinding belt
10 Grinding belt
11 Fixing screws for grinding disc
cover
12 Grinding disc cover
13 Bore holes for table mounting
14 On/off switch
14a On switch
14b Off switch
15 Fixing screws for grinding disc
cover
16 Grinding disc cover
17 Star grip nut to mount/adjust the
workpiece support grinding disc
18 Workpiece support grinding disc
19 Grinding disc
20 Upper (a) and lower (b) roller
GB IE
.. 2950 min
-1
0
21