Cleaning And Servicing; Working With The Blender; Cleaning The Base Unit - Bosch MUM59 serie Gebrauchsanleitung

Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous­feed shredder
and empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in
an anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise
direction and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Figure J).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until
the drive is at a standstill! Operate the
assembled blender only and with the lid
attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max. 0.5
litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep­frozen ingredients (except ice cubes).
Do not operate blender when empty.

Working with the blender

Figure K:
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anti­clockwise direction.
Cleaning and servicing
■ Add ingredients.
Maximum capacity – liquid = 1.25 litres;
maximum capacity frothing or hot liquids
max. 0.5 litres; optimal processing
c apacity – solids = 50­100 g;
■ Attach the cover and turn anti­clockwise
all the way into the blender handle. The
cover must be locked in position.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
Figure K-8:
■ Switch off the appliance with the rotary
switch.
■ Remove the lid and add ingredients.
or
■ remove the funnel and gradually add solid
ingredients through the refill opening.
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the blender in a clockwise
direction and remove.
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

The attachments and accessories used
must be thoroughly cleaned after each use.
Attention!
Do not use abrasive cleaning agents. Sur­
faces may be damaged.

Cleaning the base unit

W Risk of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.
en
23