Advice For Use - Zummo Z06 Bedienungsanleitung


With the stopped machine following the previous process, DISCONNECT the MACHINE of the
POWER SWITCH (Fig. 6). The digital selector display will shut off.

Remove the cover and wipe it with a damp cloth (ATENTION!: NEVER clean it with products that
can scratch it).

The tray and blade are removed by unscrewing the nuts on the tray shafts and pulling outwards
horizontally (never extract the set throwing of the blade). Also unscrew the balls or bevel-headed
squeezers that are inside the tray that holds the squeezers (Fig. 15 & 16); underneath each one
of them there should be one washer (Fig. 22), be careful not to lose them! These pieces can be
put in the washing machine or cleaned manually. TAKE EXTRA CARE WITH THE BLADE (Fig. 3)
since it is very sharp and may cause injury.

To remove the cups, we recommend that you loosen the fastening screws a little and pull outwards;
they will be released and can then be easily removed.

WARNING! Do not was the GREY DRIP TRAY (Ref. 0508008G) using hot water or dishwasher at
temperature over 40ºC. In case of distortion of the Drip Tray, this will not be covered by the
guarantee.
Assembly
After everything is washed, put it back in place in the following order:
1 Screw on the balls is the tray that holds the squeezers. Make sure that washers are put in place
beforehand and that the balls are properly tightened.
2 Check that the rubber bands of the blade are properly in place (Figs. 19 & 20). Insert the blade
inside the tray. Assemble this set on the machine's three shafts simultaneously. (Fig. 12).
Never mount the blade on the tray afterwards!! When it makes contact with the button, fit the
projecting part of the blade into the front guide (Fig. 13).
3 Place the cups on the shafts and tighten the fastening nuts.
4 The cover is put back in place by fitting its clasps into the slots located on both front sides (make
sure that the clasps fit correctly into the slots). (Fig. 8 y 9)
Before starting up the machine, make sure that:

The tray and blade have been properly fitted into place and screwed down.

The blade has been properly fitted into place and in the horizontal position.

The nuts on the cups are properly tightened.

The correct sets of balls and cups have been used (see the section entitled "accessories").
In the event that the tray, balls or cups were not properly fitted into place, damage may be done to these
pieces and the inside of the machine. (Problems not covered by the guarantee since they are errors
made by the operator).
Cleaning the loader
Lift the loader up and it will come off easily, with the top of the machine remaining totally uncovered.
After cleaning it, put it back in place by fitting the legs into their respective openings. (Fig. 14)

6.5. ADVICE FOR USE


Make sure you are using the right squeezing parts (Balls & Cups) for the size of fruit you wish to
squeeze. If the fruit to squeeze is too big or too small for the squeezing kit used, the quality of the
juice may decrease, getting a bitter juice flavour.

The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to squeeze.

We recommend to switch off the machine when is not going to be use. (Fig. 6)
21