Using Your Philips Bluecontrol; Treatment Schedule - Philips BlueControl PSD1321 Bedienungsanleitung

Using your Philips BlueControl

Treatment schedule

3 Insert the adapter into the wall socket
(100V-240V).
4 Insert the micro USB plug into the socket on
Philips BlueControl.
- When Philips BlueControl is connected to
the mains, it beeps once and the LED
indicator starts flashing green slowly to
indicate that charging has started.
5 Always fully charge your Philips BlueControl.
When Philips BlueControl is fully charged, the
LED indicator lights up solid green.
6 Remove the adapter from the wall socket and
pull the micro USB plug out of the micro USB
socket on Philips BlueControl.
Note: Always stick to the treatment schedule.
Note: For safety reasons, the device only turns on
after identifying a skin temperature above 30°C. If
the device does not turn on, warm up the to be
treated skin and start the treatment again.
Philips BlueControl has been designed for daily
use on psoriasis vulgaris plaques. We recommend
treating single, non-overlapping psoriasis vulgaris
plaques once a day. A single treatment takes
approximately 15 minutes. If the infrared sensor
senses a too high skin temperature, the treatment
is briefly paused for safety reasons. Treatment
resumes automatically if the skin has cooled down
13
English