Items Included In The Delivery; Installation; Camera Mounting; Power Supply And Monitor Impedance - Santec VTC-279IRPWD Bedienungsanleitung

Bedienungsanleitung / User Manual
VTC-279IRPWD / VTC-280IRPWDU / VTC-289IRPWD
1. Included items
1 x camera (VTC-279IRPWD, VTC-280IRPWDU or VTC-289IRPWD)
1 x cable adapter BNC socket/plug
1 x RJ-45 adapter on screw-type terminal (only for camera VTC-280IRPDWU)
1 x Allen wrench
1 x user manual

2. Installation

(Also see the pictures on the following pages.)
This camera is a compact camera in a weather-proof housing, class IP-66. It comes with a
wall bracket and integrated cable management. You will find the technical data at the end of
the manual.

2.1 Camera mounting

Make sure to fix the camera onto a solid basis which is capable to carry the weight of the
camera. Ensure that the camera is safely installed by using only suitable screws.

2.2 Power supply and monitor impedance

Only use a stabilised 12 V DC or 24 V AC power supply unit with sufficient wattage (see
chapter "Technical specifications" for recommended power supply units).
Only approved cables should be used.
If a monitor is connected directly, the monitor impedance has to be set to 75 Ohm. Verify the
position of the switch in case the video picture is of poor quality.
Power supply is being connected to the red cable plug (mid pin +, outside -) (for DC
operation). The yellow BNC plug is for the video output.
A cable adapter BNC socket/plug is included in the delivery which can be put onto the
additional video output, e.g. to connect a monitor during the camera installation phase in
case the regular cable has already been laid (picture 2).
Camera VTC-280IRPWDU is equipped with a RJ-45 system connector.

2.3 Camera housing

The camera housing must not be opened! All camera adjustments and connections are
accessible from the outside.
Improper handling of the appliance will invalidate the warranty.
_________________________________________________________________________________
- 28 -