Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungsanleitung / User manual
VTC-HDH444IRPWDU
1. Included items
1 x camera VTC-HDH444IRPWDU
1 x RJ-45 adapter on screw-type terminal
1 x cable adapter BNC socket/plug
1 x Allen wrench
4 x screws
3 x screws
4 x rubber gasket
1 x screw (for cable cover at side)
1 x user manual
2. Installation
(Also see the pictures on the following pages.)
This compact camera comes in a vandal-proof housing, IP-66 classified. It is suitable for wall
or ceiling/surface mount.
You will find the technical specifications at the end of this manual.
2.1 Camera mounting
Make sure to fix the camera onto a solid basis which is capable to carry the weight of the
camera. Ensure that the camera is safely installed by using only suitable screws.
2.2 Power supply and monitor impedance
Only use a stabilised 12 V DC or 24 V AC power supply unit with sufficient wattage (see
chapter "Technical specifications" for recommended power supply units).
Only approved cables should be used.
If a monitor is connected directly, the monitor impedance has to be set to 75 Ohm.
Verify the position of the switch in case the video picture is of poor quality
See picture 1 for power supply and video connection.
A cable adapter BNC jack/plug is included in the delivery which can be put onto the
additional video output, e.g. to connect a monitor during the camera installation phase in
case the regular cable has already been laid (picture 7).
2.3 Camera housing (picture 4)
Open the camera housing by loosening the screws carefully.
Carefully twist off the housing from the camera module. Make sure that the rubber gasket is
not damaged.
Improper handling of the appliance will invalidate the warranty.
_________________________________________________________________________________
- 31 -
Werbung
Inhaltsverzeichnis
