Included Items; Bracket And Camera Installation - Santec VTC-HDH422PWD Bedienungsanleitung

Bedienungsanleitung / User manual VTC-HDH422PWD /
VTC-HDH432IRPWD / VTC-HDH444PWDU

Included items

1 x camera VTC-HDH422PWD, VTC-HDH432IRPWD or VTC-HDH444PWDU
1 x RJ-45 adapter for power supply (only for camera VTC-HDH444PWDU)
1 x adapter BNC jack/plug
1 x Allen wrench
4 x screws
3 x screws
4 x rubber gasket
1 x screw (for cable cover at side)
1 x user manual
Installation
(also see the following pages)
This compact camera comes in a vandal-proof housing, IP-66 classified. It is suitable for wall
or ceiling/surface mount.
You will find the technical specifications at the end of this manual.

Bracket and camera installation

1.
Fix the camera onto a solid basis which is capable to carry the weight of the camera.
Ensure that the camera is safely installed by using only suitable screws.
2. Power supply and monitor impedance
Only use a stabilised power supply unit with sufficient wattage (see "Technical specifications"
for recommended power supply). Only approved cables should be used.
If a monitor is connected directly, the monitor impedance has to be set to 75 Ohm.
Verify the position of the switch in case the video picture is of poor quality
See picture 1 for power supply and video connection.
A cable adapter BNC jack/plug is included in the delivery which can be put onto the
additional video output, e.g. to connect a monitor during the camera installation phase in
case the regular cable has already been laid (picture 7).
3. Camera housing (picture 4)
Open the camera housing by loosening the screws carefully.
Carefully twist off the housing from the camera module. Make sure that the rubber gasket is
not damaged.
Also see the pictures on pages 32-34.
Improper handling of the appliance will invalidate the warranty.
_________________________________________________________________________________
- 29 -