Special; Exit - Santec VTC-279IRPWD Bedienungsanleitung

5.9 Special

Language:
Select the OSD menu language.
The default language is German.
Title:
Define whehter the camera title/name should be displayed in the picture or not.
Communikation (only for camera VTC-280IRPWDU):
Used to configure the RS-485 port.
o ID:
Set the ID for the RS-485 port (0 – 255).
If several cameras are connected in the same RS-485 branche, every camera
has to have its own camera ID.
o Baud Rate (default: 9600):
Define the Baud rate for the RS-485 port (2400 – 9600).
o Protocol:
By default, Pelco D is supported.
DPC (Dead Pixel Compensation):
If enabled, the camera runs a dead pixel compensation procedure.
Factory set:
If enabled, all adjustments are reset to factory default settings.

5.10 Exit

Save & Exit:
Exit the OSD menu while the settings are saved.
Exit:
Exit the OSD menu without saving the settings.
_________________________________________________________________________________
VTC-279IRPWD / VTC-280IRPWDU / VTC-289IRPWD
- 40 -
Bedienungsanleitung / User Manual