Attaching The Lamp Arm/Short Arm; To The Lamp Post; User's Manual; Base - KaWe Masterlight Gebrauchsanweisung

• Swivel the short arm upward.
• Tighten the four set screws (see marking) by hand.
• Mount the short arm and attached lamp onto the stand post as de-
scribed in section 13.2.2.
13.2.2 Attaching the lamp arm/short arm to the lamp post
The stand post has a socket on its upper end in which the pins on the
cross arm or the short are inserted.
The stand post comes with a fully retracted telescoping tube.
As the telescope has an integrated spring counterbalance system that
keeps the mounted light body exactly in the desired location, for trans-
port reasons, it is secured by screw 1 in its fully retracted position. This
screw is to be removed in the following manner: Hold the telescoping
tube steady and after removing the screw, allow it to slowly extend
until it is all the way out.
30

14. USER'S MANUAL

14.1 Base

The 5-footed floor stand has two locking castors, which are located
opposite one another. The castor is locked by pressing down on the
tab in front of the castor. The castor can be unlocked by gently lifting
up on the tab.

14.2 Stand post

The height of the stand post can be infinitely adjusted with just one
hand and remains precisely positioned at the desired height.
The height can be adjusted by simply lifting the telescoping stand post
2. The post will stay at the selected height.