Stand Base Assembly Instructions, User's Manual
Assembly Instructions STAND FOOT – STAND TUBE
10. SAFETY NOTICE
The floor stand may only be plugged into an electrical
outlet after it has been fully assembled.
Repair work on the stand and especially assembly work
on the sliding contacts may only be performed by us or
by someone authorised by us to do so.
The manufacturer is only responsible for the safety of
the stand if repairs and modifications were performed
by the manufacturer or at a place that is guaranteed to
comply with the safety regulations.
The manufacturer is not liable for any injuries or prop-
erty damage if the stand is not used for its intended
purpose or operated incorrectly.
General information
These assembly instructions must be stored with the
user's manual for the examination light for future
reference.
All KaWe examination lights are delivered with all of the parts required
for assembly and connection.
In order to reduce the packaging volume, the five-footed base of the
floor stand comes disassembled. The stand post is always assembled
as one piece and must only be attached to the base with its lower
fastening screw.
The KaWe examination light (stand post or cross arm) is equipped
with an integrated power cord and safety plug.
The electrical outlet used must be installed according to IEC and VDE
0107 regulations.
Check to see if there is a Schuko electrical outlet within the operating
range of the light.
28
11. ASSEMBLY OVERVIEW
Stand height adjustable - for KaWe examination lights with short,
fixed arm.
12. SUMMARY TABLE
Stand base – stand post – cross arm
Data by lamp type:
Primary
Power supply
Secondary
Transformer
Number of feet
Foot length
Stand base
Castors Ø
Note
Length approx.
Diameter
Stand post
Telescoping
Power cord
connection
Cross arm +
Assembly
light body
Light
230 V AC
(120 V AC optional)
24 V (DC at 18 and 20 LED)
50 W (60 W at 18 and
20 LED)
5
310 mm
50 mm
Weighted
84 - 138 cm
40 mm
Yes
None
Light body on stand