Assembly Instructions; Stand Assembly; Stand Base Assembly; Light Body On Stand - KaWe Masterlight Gebrauchsanweisung

13. ASSEMBLY INSTRUCTIONS

Parts included:
• Stand base – five-foot base with profile feet and hardware
• Stand post
• Light body with short arm / cross arm
• Assembly instructions
• User's manual for the KaWe examination light

13.1 Stand assembly

13.1.1 Stand base assembly

The assembly procedure for the stand base is the same for all models.
Assemble the stand base as follows:
• Insert the supplied hex nuts 1 into the depressions 2 on the connec-
tion struts.
• Press the plastic sleeves 3 onto the nuts.
• Place the metal disc 4 into the depression on the centre piece 5.
Note: Ensure that the feet with the locking castors are posi-
tioned such that they are exactly opposite one another (see
detail A).
• Insert the included screws 7 and the spring washers 8 into the bore-
holes and tighten them with a wrench until the feet are fastened
securely.

13.1.2 Light body on stand

Telescoping floor stand
Before placing the stand post onto the base, ensure that the grounding
strip 9 on the foot is bent such that the fastening screw can be inserted
through the hole on the grounding strip.
Light body on stand
Insert the stand post into the base and secure it with the included
wing nuts 13 and washers 14.

13.2 Lamp arm/short arm and light body assembly

13.2.1 Attaching the examination light to the short arm
Before the short arm can be secured to the stand post, the light body
must be attached to the short arm.
Position the light body and the short as shown. The peg of the short
arm must be rotatable in the downward direction.
Insert the light completely into the short arm.
29