Maintenance Petrol Motor; Cleaning Of The Water Filters; Maintenance At Expense/Dibo Technicians; Description Daily Control - Dibo PTL-S Bedienungsanleitung

6.2.5. Maintenance petrol motor

For maintenance activities to the petrol motor we guess to consult the supplied instructions for use of the mo-
tor. Recommended oil: 1.836.010.
6.2.6. Cleaning of the water filters
Clean the water filters regular and remove possible dirt.

6.2.7. Maintenance at expense/DiBO technicians

For further maintenance we advise to contact your DiBO distributor concerning a maintenance contract.
The maintenance applies to normal company circumstances.
At heavy circumstances you can communicate this so that can be taken into account.
Supplement documents:
Control manual
CE- certificate
Electrical plans
Remarks:
It is recommend the preventive maintenance to carry out by a competent DiBO- service technician accord-
ing to this maintenance diagram, to be able to remain use the machine up to maximum and also to be able to
claim the guarantee conditions.
To be able to guarantee a good and regular maintenance, we advise the owner/user at strongest to make an
appointment with DiBO against reaching the given up company hours, concerning a maintenance turn.

6.3 Description daily control

6.3.1. Frame

Check the frame in its entirety at loose bolts and/or cracks of the welds.
Keep the machine as much as possible clean to prevent act on dirt, water, oil and messed fuel.

6.3.2. Valves + manometer

At an switched off machine, this means a halted engine, the manometer must reflect 0 bar.
At an maximum performing machine, this means operated at full load working engine, the manometer can not
indicate more than the maximum pressure by DiBO indicated, for your machine.
After operation and releasing the gun can still remain a small pressure remainder present.
The reflected value of the manometer must be between 0-30 bar, the valves are then all right.

6.3.3. High pressure pump

Check the pump on loose connections, bolts, seals and leaks.
Check regularly the oil level of the pump. If the oil level has decreased too much or pollution of oil is ob-
served, should these be replaced before working further. Put the machine on a horizontal base.
The oil level must stand halfway the level glass.
Take at doubt the oil level stick separately, where the oil level must stand between both mark lines.
If pump oil gives a milky impression, frequently indicates this on an internal leak as a result of which water
touched oil there. Immediately repair is necessary then.

6.3.4. High and low pressure part

Check the hoses, piping and connections on external damages and leaks.
If damaged or if leaks are present, these must be immediately replaced.

6.3.5. Spray tools

Check lances and guns on leaks, external damages and hair cracks.
If damaged or leaks these must be immediately replaced.
Check the spray image of the water jet, if these blows out to much you must replace the nozzle.
Check protective cap- nozzle on damages and replace if necessary.
Check the thread of the couplings on external damages. At damage let these replace without delay.

6.3.6. Electrical part

Checks visible electric wiring and components (among other things switches) on external visible damages.
If damaged let replace the concerning parts.
DiBO n.v. 56