Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Connection - Scheppach bgs 700 Originalanleitung

Vorschau ausblenden Andere Handbücher für bgs 700:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
sition when plugged in.
doors, use only extension leads intended for outdoor use
and so marked.
and do not operate the tool when you are tired.
should be carefully checked to determine it will oper-
ate properly and perform its intended function. Check
for alignment of moving parts, binding of moving parts,
breakage of parts, mounting and any other conditions
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced by
an authorized service center unless otherwise indicated
in this instruction manual. Do not use the tool if the
switch does not turn it on and off.
than one recommended in this instruction manual may
present a risk of personal injury.
original spare parts, otherwhise this may result in con-
siderable danger to the user.
Additional Safety Rules for Bench Grinders
keeping the distance between the guard and the wheel
ly, so as to compensate the wear of the wheel, keeping
the distance between the work rest and the wheel as
of the grinder. Do not attempt to machine an undersized
be started and run at idle speed for one minute before
applying the work.
of the wheel only.
ant can weaken the bonding strentgh of the wheel and
cause it to fail.
er. Dress the wheel on the face only. Dressing the side of
the wheel can cause it to become too thin for safe use.
grinder. Do not use a wheel that is rated lower than the
grinder speed.
For belt grinders
Equipment, fig. 1
-
1.
Screening grid
5.
Lamp
6.
Grinding disc protection guard
9.
Container for cooling water
11. Abrasive belt protection guard
13. Adjusting grip for the running of the belt
15. Grinding disc pinch roll
16. Connecting piece
-
Warning!
until all installations and adjustments are completed and
you have read and understood sthe safety and operation
instructions.
Assembly bgs 700
Work Rests (Fig. 1, Nr. 4)
-
star handle screw, disk and hex-nut M6. The separation
-
Spark Guards (Fig. 2)
Install the spark guard with a cross-head screw
a washer to the wheel guard. The distance to the wheel
Screening grid (fig.3, fig.4)
flat head screw M6, a washer and a nut.
Fix the complete unit to the wheel guard with U-handle,
hex bolt M8 and a washer.
The guard is individually adjustable, as to protect the users
eyes during grinding process.
-

Electrical connection

The installed electric motor is factory connected ready for
operation.
-
tions.
The connection made by the customer as well as any ex-
tension cables used must comply with all relevant regula-
tions.
Important note
The motor rating is S 1. This means that when overloaded
it switches off automatically. After a cooling period (can
Assembly
and
-

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis