Conel FLOW Montage- Und Betriebsanleitung Seite 34

Set up/installation | For ground set up
Installation of securing brackets
Keeps the lifting unit safely in place, even in case of flooding.
1. Place the lifting unit in the desired installation location.
2. Secure unit to the ground with the aid of the brackets (see appendix, fig. 4.1).
Connection of discharge pipe
1. Use a PVC discharge pipe with an outside diameter of 40 mm.
2. Push the pipe from the outside about 20 mm into the rubber sleeve (use a
lubricant if necessary) and secure it from the inside with the existing hose clamp.
Washing machine/dishwasher connection
1. Remove the stopper from the left or right centre opening.
2. Insert the hose adapter from the inside.
3. Push on the washing machine hose and secure with suitable hose clamp.
Other side inlets
1. Remove the stopper of the desired connection.
2. Push the supply line from the outside approx. 30 mm into the rubber seal (use a
lubricant if necessary).
Vertical inlet: sink connection
1. Remove the stopper in the tank cover.
2. Push the siphon down into the corresponding opening.
3. Connect the siphon loosely to the sink.
4. Determine the pipe length (allow approx. 20 mm of the pipe to enter the unit), cut to
size and carry out final assembly.
Separate vent line
1. For sensitive applications vent the unit above the roof.
2. To do so, use the centre side tank opening.
3. Remove the stopper.
4. Push the vent line from the outside approx. 30 mm into the rubber seal (use a
lubricant if necessary).
5. Open the cover of the breather/vent valve in the container cover. Insert the
separately supplied cover cap.
34