Mains Connection; Connecting The Pressure Line; Adjustment Of The Float Switch - FLORABEST FTS 1100 D4 Originalbetriebsanleitung

G B I E N I

Mains Connection

is designed for connection to an earthed
wall socket with a residual current operat-
ed device (RCD switch) at 230 V ~ 50Hz.
Connecting the Pressure
Line
1. Screw the quick-connect adapter
(9) onto the pump outlet (6).
2. Press the red release button on
the quick-connect adapter (9)
and slide the angle adapter with
quick-connect connector (10)
into the quick-connect adapter
(9). Let go of the red release but-
ton again.
3. Fit the hose over the reducer (11)
and secure it with a hose clamp.
Or use a screw connection on
the angle adapter with quick-
connect connector (10), or on
the reducer (11).
Œ
Outlet with a 1½" internal thread on
the pump for connection of the quick-
connect adapter (9) or for direct con-
nection of a hose with a 1½" external
Outlet with 1½" external thread at the

bracket adapter (10) for connection of
the reducer (9) or a 1½" screw con-
Outlet on reducer (9) for connection of
Ž
a 1¼" or 1½" hose as a compression
1 0
CY
Outlet with 1" external thread at the

reducer (9) for connection of a 1"
Outlet with 1½" thread at the reducer

(9) for connection of a 1"hose as clamp
Note that the particle size may
be max. 19 mm if the reducer
19
the reducer and hose can become
blocked.
Adjustment of the float
switch
it can be started up immediately.
In the case of stationary installa-
tion, check regularly (no less then
once every three months) that the
(
switch height adjustment (8) and
move it to the desired position.
- It must be positioned so that it
switching point heights "On"
and "Off" must be easy to
reach.
Check this by placing the pump
carefully by hand and then low-
er it again. In this case, you can
see whether the pump switches
on and off.
7) is adjusted so that
( 7) is working.
1
7).
7)