Initial Operation; Mount Carrying Handle; Setting Up; Mains Connection - FLORABEST FGPS 1100 C3 Originalbetriebsanleitung

• Ensure that the mains voltage
the rating plate.
• The electrical installation shall be
according to national wiring rules.
• Connect the equipment only to
a socket with a residual current
protection device (residual cur-
rent circuit breaker) with a rated
not to be repaired, but rather
replaced by new ones. Have
any damage to your equipment
repaired by a specialist.
ment is damaged, it must be
son in order to prevent hazards.
socket by the cable. Protect the
edges.
ment by the cable.
• Use only extension cables that
-
-
1
-
-
-
-
ment, during work breaks and
nection lines must be no smaller
than rubber hose lines with
the designation H07RN-F. The
power cable wire cross section
must be at least 2.5 mm

Initial Operation

Mount carrying handle

Fix the carrying handle (7) to the
screws (8).

Setting up

screw it together with the base. A screw
the drain screw (
• Always put up the garden pump at a
Where this is impossible, install a low
between the appliance and the suction

Mains Connection

The pump you have purchases is already
at 230 V~ / 50 Hz.
G B M T
-
-
2
10).
1 9
-