Initial Start-Up - BWT Duo-DVGW 2 Einbau- Und Bedienungsanleitung

EN

7 Initial Start-up

Check that the unit has been properly installed.
Units 6 and 10 only: The unit may not be started for at least one hour
after filling the disinfectant solution (see Installation).
Open the water supply slowly and plug in mains plug.
0 l/h 00 : 00 : 01
The display shows BWT followed by the Regeneration screen.
The current water flow, the time and the regeneration procedure are
shown here.
0 00 : 00 : 19 Cancel regeneration.
Press the Browse button
Set the cursor to Manual
Press OK
Set the cursor to Cancel regeneration
H O
2
NaCL
NaCL
Press OK to confirm for 1. Column
Press OK to confirm for 2. Column
Regeneration is cancelled.
Press the Browse button twice
l / h Time
The current water flow, the time and the supply of softened water are
now displayed.
Current softened water supply
See the following page for further Start-up steps
37