BWT Duo-DVGW 2 Einbau- Und Bedienungsanleitung Seite 35

Rondomat Duo DVGW 6 and 10 terminal plan
1 2 3 6 4
B
Power
Netzteil
supply
unit
Remove mains plug.
Fasten the DVGW electrolysis unit to the back of the Soft Control console using the supplied screws and fastenings.
Connect wire A to the valve block and to the electrolysis cell using plugs.
Connect wire B to the terminals on the Soft Control controller.
The mains plug of the Soft Control controller can be removed and the cable can be connected to terminals L, N of the DVGW
electrolysis unit.
Soft Control II
Soft Control II
5 7 8
Electrolysis
Elektolyse
DVGW
DVGW
Valve block Ventilblock
5 2 1 7
Electrolysis cell
6 Elektolysezelle
8
4 3
4 1
3 2
EN
35