Milling With Parallel Stop; Milling With Template Guide; Milling With Centring Tip; Cleaning/Maintenance - Parkside POF 1200 C2 Originalbetriebsanleitung

Milling with parallel stop

You can mill notches and profiles with the
parallel stop by moving the parallel stop
along the workpiece edge at a pre-set
distance.
1. Insert the parallel stop (24) with
the guide bars (29) into the guide
rails (15) of the baseplate (10).
Tighten the retaining screws (9).
2. Move the turned on machine
along the workpiece edge with
lateral pressure on the parallel
stop (24).
Milling with template
guide
By means of the template guide (25), you
can transfer contours from templates to
workpieces.
Inserting the template guide:
1. Screw off the suction adapter as applies.
2. Insert the template guide (25) into the
sliding plate (11). The ball race (26)
must point down.
3. Fasten the template guide (25) to the
recessed head screws (21) that are in-
cluded in the delivery.
Inserting the cutter:
4. Insert a cutter that has a diameter
smaller than the inner diameter of the
template guide (25).
5. Set the desired cutting depth (see "Ini-
tial operation").

Milling with template guide

6. Loosen the clamping lever
( 19) and lower the machine down-
ward until the previously set cutting
depth is reached.
7. Move the machine with protruding tem-
plate guide (25) along the template.
Apply slight pressure during this work.
The template must be at least as
high as the ball race (26) of the
template guide (25).

Milling with centring tip

By means of the centring tip, you can do
circular milling work.
1. Turn the parallel stop (24) around so
that the stop edge points up.
2. Screw on the centring tip (23) on the
parallel stop by means of the butterfly
nut. In the process, counter lock the
centring tip in the long hole of the com-
bination wrench (
3. Screw the guide bars (29) of the paral-
lel stop (24) on the baseplate (10) and
tighten the retaining screws (9).
4. Push the centring tip (23) in the marked
centre of the circle to be cut.
5. Move the machine circularly once in
the circle around the centring tip (23).

Cleaning/maintenance

Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts. In this way you avoid dam-
age to the appliance and possible
injury to people.
Pull out the power plug before car-
rying out any work on the equip-
ment. There is a risk of electrocution
or of injury from moving parts.
GB MT
27).
51