Operation; Switching On And Off; Pre-Selecting The Rotation Speed - Parkside POF 1200 C2 Originalbetriebsanleitung

1. Place the machine with inserted cutter
on the workpiece to be processed.
2. Turn the step limit (14) until it engages in
the lowest step below the depth stop (17).
3. Loosen the clamping lever (19) by turn-
ing it upward.
Loosen the clamping lever (19) by
pushing it upward.
4. Slowly press down the machine until
the cutter contacts the workpiece.
5. Fasten the clamping lever (19) by turn-
ing it to the left.
Rough adjustment:
Release the locking screw (18) on the
depth limit (17).
6. Adjust the depth stop (17) to the de-
sired cutting depth, using the step limit
(14) if necessary, and tighten the lock-
ing screw (18).
Fine adjustment:
7. Set the scale below the rotary knob (2)
to the "0" position. For this purpose,
press the ring (2a) below the rotary
knob downward and turn it into the de-
sired position. If you have used the step
limit (14) for the rough adjustment, turn
it again until it engages in the lowest
step below the depth stop (17).
8. For the fine adjustment, turn the rotary
knob (2) to the desired measure, where-
in one complete rotation equals 1 mm:
Counter-clockwise rotation:
greater cutting depth.
Clockwise rotation: lesser cutting depth.
Once you have set the desired
cutting depth, turn the step limit
(14) until it engages in the lowest
step below the depth stop (17).
We recommend testing the cutting
depth adjustment by means of a test
cut on a reject piece.
Gradual milling
To mill in multiple steps with greater cutting
depth, the cutting depth can be adjusted
with the step limit (
1. Turn the step limit (
engages in the highest step below the
depth stop (
2. Set the further cutting depth with the
lower steps of the step limit (

Operation

Wear breathing protection
(fine dust mask of protection class
FFP2).
Do not wear gloves while milling.

Switching on and off

1. Connect the machine to the
power supply.
Make sure that the net voltage matches
the voltage rating indicated on the de-
vice's type plate.
2. Switching on: Keep the safety lock (5)
pressed and press the on/off switch
(6). Then release the safety lock.
3. Switching off: Release the on/off switch
(6).
Pre-selecting the rotation
speed
You can pre-select the maximum rotation
speed on the handwheel for the rotation
speed pre-selection (
• Adjust the desired rotation speed on
the handwheel for the rotation speed
preselection (
GB
14).
14) so that it
17).
14).
3).
3).
MT
49