Introduction; Intended Purpose - Parkside POF 1200 C2 Originalbetriebsanleitung

Content
Introduction ............................... 41
Intended purpose ....................... 41
General description .................... 42
Extent of the delivery ...................... 42
Functional description ..................... 42
Overview ...................................... 42
Technical data ............................ 43
Safety instructions ...................... 43
Symbols in the manual .................... 43
Symbols on the appliance ............... 44
General Safety Directions
for Power Tools ............................. 44
Safety notices for milling cutters ....... 46
Residual risks ................................. 47
Initial operation ......................... 47
Inserting/changing cutters ............... 47
Change collet chuck ....................... 48
Connecting the suction adapter ........ 48
Mounting the parallel stop ....................48
Adjust cutting depth ........................ 48
Operation .................................. 49
Switching on and off ...................... 49
Pre-selecting the rotation speed ........ 49

Introduction

Congratulations on the purchase of your
new device. With it, you have chosen a
high quality product.
During production, this equipment has been
checked for quality and subjected to a final
inspection. The functionality of your equip-
ment is therefore guaranteed. It cannot be
ruled out that residual quantities of lubri-
cants will remain on or in the equipment in
isolated cases. This is not a fault or defect
and it represents no cause for concern.
The operating instructions constitute
part of this product. They contain
important information on safety, use
and disposal.
Practical tips .............................. 50
Milling .......................................... 50
Edge and profile cutting .................. 50
Milling with parallel stop ................. 51
Milling with template guide ............. 51
Milling with centring tip .................. 51
Cleaning/maintenance ............... 51
Cleaning ....................................... 52
General maintenance ..................... 52
Storage ...................................... 52
Waste Disposal/
environmental protection ........... 52
Spare parts/accessories ............. 53
Troubleshooting ......................... 54
Guarantee ................................. 55
Repair service ............................ 56
Service-Center ............................ 56
Importer .................................... 56
Translation of the original EC
declaration of conformity ............ 79
Exploded Drawing ..................... 81
Before using the product, familiarise
yourself with all of the operating
and safety instructions. Use the
product only as described and for
the applications specified.
Keep this manual safely and in the
event that the product is passed on,
hand over all documents to the third
party.

Intended purpose

The machine can be used for cutting
notches, edges, long holes and profiles,
and it is suitable for contour milling on
workpiece surfaces such as wood, plastics,
GB MT
41