General Advice - Scheppach mt 180t Aufbauanleitung

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We wish you success and hope you will enjoy working
with your new universal saw stand.

GENERAL ADVICE

• After opening please check all parts for possible da-
mage during shipping. In case of a grievance, ple-
ase contact the retailer from whom you purchased
the universal saw stand. Later complaints will not be
accepted.
ATTENTION
The device and the packaging materials are not toys!
Children must not play with plastic bags, foils and
small pieces!
Items delivered, Fig. 1
1. Base frame
2. Support pole
3. Handgrip
4. Wheels with ball bearing 2x
6. Guide rollers 2x
7. Wheel bolts 2x
8. Handgrip (table)
Pan head screw (M6x35) 2x
Locking nuts 2x
Pan head screw (M6x12) 4x
Arc washers 4x
Star knob screw 4x
Star knob 2x
Carriage Bolt (M8x45) 4x
M8 nut 4x
Spring washers 4x
Flat washers 4x
Assembly
Fig. 2
Insert the two end caps into the support pole and then
insert the support pole (2) with end caps into the base
frame, securing it with 2 pan head screws (M6x12) and
2 arc washers.
Fig. 3
Insert the handgrip (3) into the base frame, securing it
with 2 pan head screws (M6x12) and 2 arc washers.
Fig. 4
Insert the wheel bolts (7) with ball bearings and wheel
(4) through the wheel socket on the frame and tighten
with the locking nuts (8). Take care that the wheels are
still able to move.
Fig. 5 - 5.1
Secure the Phillips-screw (1) with the star knob (c).
Repeat this process also on the other side.
Stand the device on the support pole and wheels, pull
the ratchet lever (a) and pull the worktop (b) up until it
latches.
Warning! Crushing hazard
Secure with star knobs (c) on both sides.
Fig. 6
Slide the extension tube (5) into the square tube as
far as the guide sleeve allows and secure with the star
knob screws (e).
Fig. 7
Insert the guide rollers (6) into the square tube of the
extension and secure with the star knob screws (f).
Fig. 8 / 8.1
The universal saw stand assembly is complete in
Position 1 (Work height = 82 cm)
Position 2 (Work height = 68,5 cm)
Position 3 (transport position)
Fig. 9
For storage, position the universal saw bench upwards.
Fig. 10
Assemble the handle with two pan head screws (M6x35)
on the table as you can see on the picture.
5