General Instructions; Safety Instructions - Scheppach wox d 700 Bedienungsanleitung

General instructions

• After unpacking please check all parts for possible damage during transport. In case of complaints the driver needs to be con-
tacted as soon as possible.
• Complaints coming in later will not be recognized as such.
• Check if the consignment is complete.
• Familiarize yourself with the machine by means of the operating instructions before implementing it.
• In case of replacing worn or exchange parts, as for accessories, only use original Scheppach parts. You can obtain exchange
parts at the specialized dealer.
• Upon ordering, please specify our article nºs as well as type and year of construction of the tool.

Safety instructions

In these operation instructions we have indicated positions that concern your safety, with this mark.
Training of the operator
• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Do not wear tight clothing. Take off jewelry, rings and wristwatches.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Take notice of all safety and danger information of the machine and keep them readable.
Steadfastness
• Please be vigilant the machine is steadfast while being assembled.
Power supply line of the machine
• Check power supply lines. Do not use defective lines. See "Electrical connection".
• Pay attention to the motor and tool rolling direction. See „Electrical connection".
• Installations, repairs and maintenance installations to the electrical installation should only be carried out by experienced staff.
• To repair disorders switch off the machine. Pull out the power plug.
• Upon leaving the work site switch of the motor. Pull out the power plug.
• Also at the slightest movement of the machine disconnect it from any external power supply! To restart orderly reconnect the
machine to the power supply!
Warning! This electric tool generates an electromagnetic field during operation. This field can impair active or passive medical
implants under certain conditions. In order to prevent the risk of serious or deadly injuries, we recommend that persons with medical
implants consult with their physician and the manufacturer of the medical implant prior to operating the electric tool.
m
Additional safety instructions for Cardan shaft operation
• In the case of tractors with hydraulic or compressed air actuated power take-off couplings, a free-wheeling Cardan shaft must be
used.
• Bring the machine to a standstill, switch off the tractor and remove the ignition key before rectifying faults or removing jammed
pieces of wood.
• Switch off the tractor and remove the ignition key when leaving the workplace.
• The power take-off coupling must be switched off when transporting the circular saw.
• The DIN 110030 warning sign with rear lights must be attached to the saw and the rear lights connected to the tractor.
• The circular saw is only permitted to be operated on tractors with category 1 or 2 three-point attachments and a rotational speed
of 540 rpm.
• Do not work with too slow a rotational speed. The saw blade can jam and cause the overload coupling to slip.
• The saw shall only be operated with the overload coupling installed ahead of the Cardan shaft.
• Uncouple the Cardan shaft to replace the saw blade.
GB
Seite:71