Kessel EasyClean ground Standard NS 25 Anleitung Für Einbau, Bedienung Und Wartung Seite 25

The telescopic KESSEL upper section
must be shortened to such an extent that all installed parts are
easy to service. Before insertion, chamfer by 15° to avoid da-
mage to the sealing gasket, the upper section can be inclined
by up to 5°. Then insert the upper section into the opening of the
separator and move it to the required position. With the aid of
the existing clamping ring it is now possible to fasten the upper
section in the desired position (alignment with the top ground
surface). The fine adjustment to the final height is then effected
with the adjusting screws. A ground slope can be compensa-
ted for with the continuously height-adjustable and up to 5°
inclinable attachment piece. The upper section must be lined
sufficiently and made flush with the ground level using a flat-
Auf der Rückseite der
Do not grease on the
exterior side of the seal Dichtung nicht
fetten
Lippendichtung
Behälterdom
2019/02
Installation and assembly
Grease sealing lips (only grease inside the seal) (Dichtlippen fetten)
Lip seal
Tank dome
Wenn das
If the upper
section needs to be
Aufsatzstück
shortened, cut at a
gekürzt wird
15° angle as shown.
muss eine
15° x 20 mm Fase
angebracht werden.
bed vibrator and a steel plate placed over the upper section.
For larger installation depths, the special KESSEL adapter (art
no. 917460), installation height 500 mm, must be used.
Remaining filling
For installation in areas driven over by trucks (cover Class D), a
reinforced concrete plate must be designed as the uppermost
layer. A respective formwork plan and reinforcement drawing
can be provided by KESSEL.
25/96
Telescopic upper section
teleskopisches
Aufsatzstück
Minimum insertion
Mindestein-
depth of upper section
stecktiefe
min. 20 cm of free space
mind. 20cm Freiraum
010-223