Safety Instructions - Kessel EasyClean ground Standard NS 25 Anleitung Für Einbau, Bedienung Und Wartung

2019/02

Safety Instructions

Personnel used for installation, assembly, operation, maintenance and repair must have the cor-
responding qualifications for such work. Areas of responsibility and the supervision of personnel
must be clearly specified by the operator.
The operating safety of the system supplied is only ensured in the event of proper use. The limit
values specified in the technical data must not be exceeded under any circumstances.
Accident prevention regulations and the applicable standards and directives must be observed
at all times during installation, assembly, operation, maintenance and repair of the system!
These include:
• Accident prevention regulations
- Construction work, BGV C22
- Waste water systems, GUV-V C5
• Safety regulations for work in enclosed areas of waste water systems, GUV-R 126
• Handling of biological materials in waste water systems, GUV-R 145
• Directives for work in tanks and restricted areas, BGR 117
• Standards
- Construction pits and ditches - Embankments, shoring, working area widths, DIN 4124
- Laying and testing of waste water pipes and channels, DIN EN 1610
• Work aids for safety and health protection in waste water systems.
ACCESS:
NO SMOKING! Smoking is strictly prohibited near or around the separator at all times !
All sources of ignition or sparks are prohibited near or around the separator at all times !
SLIPPERY WHEN WET! Take caution when standing / walking near the separator. During dis-
posal, cleaning and maintenance the surrounding area can become extremely slippery due to
spilled oil.
• Dangers from gases and vapours such as the danger of suffocation,
poisoning or explosion
• Danger of falling
• Danger of drowning
• High physical and psychic stresses of work in deep, restricted or dark areas
Failure to observe these operating instructions may result in substantial material damage,
physical injuries or fatal accidents.
The system constitutes one component of an overall system. The operating instructions of
the overall system and the individual components must therefore also be observed. During all
assembly, maintenance, inspection and repair to any of the components, the overall system
must be shut down and secured against restarting.
Conversion or modifications to the system must only be made after consultation with the ma-
nufacturer. Original spare parts and accessories approved by the manufacturer must be used
in order to ensure safety. The use of other parts may invalidate liability for the resulting conse-
quences.
19/96
010-223