Abicor Binzel ABIPLAS WELD CT Betriebsanleitung Seite 36

6 Putting into operation
6.2 Setting up the ABIPLAS
1
Fig. 4 Steps for setting up the ABIPLAS
EN - 12
®
WELD 250 CT20 torch body
CAUTION
Risk of injury
Puncture or stab wounds may be caused by the tungsten electrode tip.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
2–4
®
WELD 250 CT20 torch body
1 Insert the blunt end of the tungsten electrode about 5 mm into the back cap.
2 Insert both parts into the torch body and tighten with the back cap.
3 Unscrew the back cap half a turn anti-clockwise.
4 Insert the centring ceramics into the torch body from below.
5 Screw the alignment gauge onto the torch body as far as it will go. This
pushes the tungsten electrode back to the preset setting dimension.
NOTICE
• The standard setting dimension for the electrode setting is 3 mm.
6 Fully tighten the back cap. The tungsten electrode is clamped into place.
7 Unscrew the alignment gauge.
8 Attach the insulating ring and screw on the distributor ring and gas diffuser.
9 Insert the plasma nozzle and tighten with the fastening nut.
10Screw on the gas nozzle.
5–7
3 mm
®
ABIPLAS WELD CT
8–10
BAL.0128 • 2018-02-05