Vacuuming The Tube Film - Silvercrest SFS 120 A1 Bedienungsanleitung

Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
CAUTION – PROPERTY DAMAGE!
► Do not evacuate bags that contain liquids. These will get into the appliance
and damage it.
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring
be inserted no further than the rear limiters
limiters
2) Close the appliance lid
click closed. If necessary, press them down once again on the markings
and
NOTE
► Ensure that the upper
Otherwise the device cannot suck the air out of the bag.
► If either one of the sealing rings
groove and press the replacement sealing ring into the groove.
■ 58 │ GB │ MT
. Otherwise the vacuuming and welding will not function correctly:
. Ensure that both corners of the appliance lid
so that the appliance lid
and the lower sealing rings
and must lie between the front
clicks into place and locks shut.
are not damaged!
/ is damaged, simply pull it out of the
. The bag should
SFS 120 A1