Vacuum Sealing; Vacuuming The Tube Film - Silvercrest VIDE SV 120 A1 Bedienungsanleitung

Vacuum sealing

Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
NOTE
► Do not evacuate bags that contain only liquids. These could be sucked up
during the vacuum sealing process.
If small quantities of liquid or food do get sucked up, they will be deposited
in the small drip tray that is located between the lower sealing ring
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring
be inserted no further than the rear limiters
limiters
2) Close the appliance lid
click closed. If necessary, press them down once again on the markings
and
NOTE
► Ensure that the upper
Otherwise the device cannot suck the air out of the bag.
► If either one of the sealing rings
groove and press the replacement sealing ring into the groove.
■ 28 │ GB │ IE
. Otherwise the vacuuming and welding will not function correctly:
. Ensure that both corners of the appliance lid
so that the appliance lid
and the lower sealing rings
and must lie between the front
clicks into place and locks shut.
are not damaged!
/ is damaged, simply pull it out of the
.
. The bag should
SV 120 A1